[. . . ] To prevent electric shocks and fire hazards, DO NOT use any other power source. Consult a dealer having special knowledge of this kind for safe and reliable installation. There may be legal regulations defining the permissible installation locations for the monitor which differ by country or by state. [. . . ] When the liquid crystal panel reaches high temperatures or low temperatures, chemical changes occur within the liquid crystal panel which may cause it to malfunction. How to reset your monitor / Zurücksettzen des geräts / Comment réinitialiser votre appareil / Het apparaat terustellen When you watch the screen at an angle, the picture might not be clear. Before operating the unit, make sure that all external components are correctly connected and installed. To turn off the power / So prüfen Sie die aktuelle Eingangsquelle / Pour mettre l'appareil hors tension / Uitschakelen van de stroom To return the angle, press the bottom end of the monitor. You can use JVC's remote controller RM-RK230, which supplied with some JVC receivers, to control the monitor. Do not expose the remote sensor to strong light (direct sunlight or artificial lighting). Controllable only if your car receiver which is connected to this monitor is one of the JVC receivers. You can use JVC's optional cordless headphones KS-HP2 to listen to the playback sounds of the external component. Playback sounds are transmitted through IR transmitters to the cordless headphones. Some noise may occur at some positions on the car depending on the car type or the window type. In that case, use the headphones at the position where no noise occurs. Some noise may occur at some positions on the car when using two or more monitors. Menu selection goes off if other operations are done or no operation is done for about 5 seconds. Initial level: 0 (center) Control the degree of difference between the lightest and darkest parts of the picture. Initial level: 0 (center) Adjust this if the human skin color is unnatural. Initial level: 0 (center) Set to "ON" when you listen to the playback sounds using JVC's optional cordless headphones KS-HP2. Initial setting: ON Adjust the light of the screen and the white LED when you turn on the headlights. Initial level: 0 (center) Light on or off the white LED when you turn on the monitor. [. . . ] Clean off dirt by wiping lightly with a soft cloth When the cabinet is very dirty, wipe with a well-wrung cloth dipped in a kitchen cleanser (neutral) thinned by water and then go over the same surface with a dry cloth. (Since there is the possibility of water drops getting inside of the unit, do not directly apply cleanser to the surface. This is a characteristic of liquid crystal panels and is not a malfunction. [. . . ]